Lecture and Meeting rooms (Bonomea main building)
All information about room booking status and availability can be found at our Scheduler
(visible only inside SISSA authenticated network)
Room Locations and Booking Contacts
| Room | Location | Capacity | Email for booking |
|---|---|---|---|
| Big Meeting Room | 7 floor, Directorate | 42 | segreteriadirezione@sissa.it |
| Council Room | 7 floor, Directorate | 20 | segreteriadirezione@sissa.it |
| Blue Reading Room | Library | 8 | library@sissa.it |
| Red Reading Room | Library | 10 | library@sissa.it |
| Magna Budinich | Garden | 512 | ufficiotecnico@sissa.it |
| 003 | 0 floor, center | 22 | lecturerooms@sissa.it |
| 004 | 0 floor, center | 42 | lecturerooms@sissa.it |
| 005 | 0 floor, center | 70 | lecturerooms@sissa.it |
| 113 | 1 floor, left wing | 15 | lecturerooms@sissa.it |
| 128-129 | 1 floor, center | 112 | lecturerooms@sissa.it |
| 130 | 1 floor, left wing | 16 | phd@sissa.it |
| 131 | 1 floor, left wing | 30 | lecturerooms@sissa.it |
| 132 | 1 floor, left wing | 30 | lecturerooms@sissa.it |
| 133 (Ambrosetti) | 1 floor, left wing | 30 | lecturerooms@sissa.it |
| 134 | 1 floor, left wing | 30 | lecturerooms@sissa.it |
| 135 | 1 floor, right wing | 30 | lecturerooms@sissa.it |
| 136 (Dubrovin) | 1 floor, right wing | 30 | lecturerooms@sissa.it |
| 137 | 1 floor, right wing | 30 | lecturerooms@sissa.it |
| 138 | 1 floor, right wing | 30 | lecturerooms@sissa.it |
| 139 | 1 floor, right wing | 30 | lecturerooms@sissa.it |
Classrooms
The new rooms are equipped with an omnidirectional ceiling microphone, 2 or 4 speakers, 2 cameras (1 aimed at the blackboard and 1 aimed at the students), 1 A/V recording system, and A/V stream management systems. The management software is based on MS Teams Room. This makes it possible to manage more than one high-resolution video stream.
The touch display always shows the main MS Teams Room interface (pictured alongside), whether the classroom equipment is on or off.
Before carrying out any other operation, you must therefore tap “Room control” and select one of the available presets.
This starts the process of switching on all the room’s peripherals (microphones, speakers, cameras, displays). Without them, Teams Room will not detect any peripherals, even though it may appear to be working. The start-up process takes approximately 90 seconds and is indicated by a progress bar.
The microphone is not active because the room has not been started up yet.
Presets
There are 4 available presets (or modes):
Blackboard lecture: for using only the blackboard and, if required, recording the lecture. Only the microphone and cameras are activated.
Slides Presentation: allows you to project slides from your laptop (a standard lecture with slides). The lecture can also be recorded in this mode. The microphone, cameras, projector, and projection screen are activated.
Hybrid session: allows you to use the room equipment with Teams ROOM. This makes it possible to transmit both camera feeds simultaneously during a videoconference (as well as any projected slides). There are two ways to project slides, both locally and remotely:
- via HDMI: simply connect the HDMI cable to the laptop;
- via Cast (available in the “…” menu next to your profile picture in Teams on your laptop): simply select the room you are in. No cable connection is required; Teams will connect to the room’s Teams ROOM system.
Laptop Mode: makes the room’s cameras, microphone, and speakers available to your laptop, allowing you to start a videoconference using software installed on your laptop (Google Meet, Zoom, Webex, etc.). Simply connect the USB-C cable to the laptop, which will then detect all the available peripherals. Not all videoconferencing platforms can manage 2 simultaneous high-resolution video streams (webcams).
Recording
The “Recorder” menu allows you to record the camera feed (the blackboard), the projected slides, and the room audio. The videos are saved to the local drive and then transferred to a platform that is still being installed.
- “Record” to start recording.
- “Stop” to stop recording.
To record a Teams meeting session, once the meeting has started:
- Tap “More options” (the 3 dots) on the meeting control page.
- Tap “Start recording” in the menu that appears.
- Tap “Stop recording” to stop the recording.
Once the recording has ended, the files will be saved to the MS cloud.